Vermont Casting Stove SDFBDVR User Manual

Front  
Stardance Front  
w/Doors Package  
Stardance Firebox and  
Stove Shell/Door  
Installation Instructions  
for Models:  
SDFBVT/SDFBVTC,  
SDFBDVR/SDFBVRC  
Right Door  
CAR208  
Left Door  
Fig. 2 Carton contents for operable door package.  
CAUTION: Handle porcelain enamel castings gen-  
tly. The finish is fragile and can be easily dam-  
aged. Place castings on a towel, carpet or other  
protective surface.  
Assembly Instructions  
1. Attach the rear skirt to the left side by aligning the  
key holes with the two wingbolts in the side. If nec-  
essary, turn the wingbolts to orient the blades verti-  
cally. (Fig. 3) Slide the skirt downward to engage it  
behind two washers on the side plate bolts and then  
tighten both wingbolts.  
To complete installation of your Stardance gas stove,  
you must first assemble the outer cast shell. Follow  
the directions for each model. Refer to Homeowner’s  
Manual for complete installation instructions.  
Side  
Rib  
Unpacking the Shell  
Wingbolt  
The Stardance shell is comprised of three cast iron  
plates plus the front with operable doors. The top plate  
for the top vent models is a single piece. The top plate  
for the rear vent models has three (3) pieces, the plate,  
screen and grate. Compare parts recieved with those  
shown in Figures 1 & 2. Carefully inspect all parts and  
immediately report any damaged or missing parts to  
your dealer/distributor.  
Left  
Side  
Steel  
Tabs  
Stardance Rear  
Vent  
Wingbolt  
Grate  
Screen  
ST470  
Rear Skirt  
Stardance  
Top Vent  
Fig. 3 Attach rear skirt to the left side.  
Top  
2. Attach the right side to the rear skirt. (Fig. 4) Move  
this assembly close to the stove’s final position. Align  
the two sides at right angles to the back panel as  
shown in Figure 5.  
Left Side  
NOTE: The firebox is shipped with three bolts and  
spacers on the bottom to prevent any damage to  
the bottom assembly. The two front bolts should be  
removed after installation. Use a 7/16” wrench.  
Right Side  
CAR207  
Fig. 1 Carton contents for Stardance shell.  
30004220 7/07 Rev. 0  
 

Texas Instruments Switch TPS54810 User Manual
Thermo Products Furnace OH6FA072D48B User Manual
Tiger Games 70 153 User Manual
TOA Electronics Security Camera C CV24 2 NTSC User Manual
Tripp Lite Network Cables N002 002 BK User Manual
Tripp Lite Surge Protector 200204173 User Manual
Tyan Computer Network Card B5381 User Manual
Uniden Cordless Telephone WDSS 5335 WDSS 5335 User Manual
Uniden Scanner UBC 2500XLT User Manual
Viper Automobile Alarm Model 160XV User Manual